Authorized Trane AC Installation in West Vancouver
Adding central air conditioning to a West Vancouver home is a one-day project for most houses that already have a furnace and ductwork. We pair an outdoor unit, the condenser, with a coil that sits on top of the existing furnace, and the furnace blower moves cooled air through the ducts that are already behind every wall. Eaton's Heating is an authorized Trane dealer with 20-plus years of AC installations across West Vancouver, from compact Dundarave lots to large hillside properties in the British Properties. The assessment is free with an all-in written quote, and 12-month zero percent financing is available through Financeit.
See what our customers have to say
Brands Serviced
Years of Experience
Homes Served and Counting
Ambleside, Dundarave and Hollyburn homes were built in the 1950s and 60s for heating, not cooling. The furnace and ductwork are there, but the ductwork was sized for winter airflow, the electrical panel may not have room for a new circuit, and nobody planned where a condenser pad would go. The assessment answers all three questions before the estimate is written: can the blower move enough air for cooling, is the panel ready, and where does the outdoor unit sit without creating a noise problem? Most of the time the answer is yes on all three, and the AC installation goes ahead on the existing system.
The British Properties, Caulfeild and Cypress Park add variables that the waterfront homes do not have. The outdoor unit often needs to sit on a terraced pad cut into a slope, sometimes a full level below the mechanical room. That means a longer refrigerant line set running vertically through or along the exterior wall, and a longer electrical run from the panel. Steep driveways and narrow access paths between houses change how the equipment gets to the pad. None of this changes the finished result, but it changes the scope of the installation, and the assessment catches all of it before a price goes on paper. In the larger British Properties homes with two furnaces, which come up often in our West Vancouver HVAC services work, both can be tied into cooling during the same project.
What goes outside depends on the lot as much as the house. On compact Dundarave lots where the outdoor unit sits a few metres from the neighbour's fence or a bedroom window, a variable-speed condenser pays for itself in quiet alone. On a large British Properties lot where the unit sits well away from living space, a mid-range single-stage unit handles the job at a lower price. Every outdoor unit is paired with the specific indoor coil it was designed to work with, and on hillside homes where the refrigerant line runs a long distance between the pad and the furnace, getting that pairing right is what keeps the system running at its rated output. If the existing system has a fixable single-part problem, AC repair in West Vancouver is the better path and we will tell you so.
The last step before we leave is commissioning: the refrigerant charge is set to the manufacturer's specification, cooling is verified at every register, and the thermostat is programmed. On systems with long line sets the charge calculation changes with every additional metre of vertical rise, and getting it right on day one is what keeps the system at its rated output for years. Eaton's Heating is TSBC licensed (LGA0200006), a Home Performance Contractor Network member, and holds a 4.9 rating across 400-plus Google reviews. For homes where the furnace is also aging, a heat pump that heats and cools from one outdoor unit is worth pricing alongside the AC, because the installation is similar and CleanBC and FortisBC rebate programs strongly favour heat pumps.
The outdoor unit needs a level pad with clearance on all sides for airflow and service access, and a position where the exhaust noise does not blow directly at a patio, a deck or a neighbour's bedroom window. On a flat Ambleside lot that is a simple conversation during the assessment. On a hillside property in the British Properties or Caulfeild, it takes more planning.
Steep lots often have only one practical pad location, and it may need grading or a poured pad on a retained shelf. The refrigerant line set runs from that pad up to the furnace, and every additional metre of vertical rise adds cost and requires the refrigerant charge to be adjusted for the longer run. We walk the lot during the assessment and show you the proposed location so you see exactly where the unit will sit before the estimate is written. Fencing, retaining walls and mature trees close to the condenser restrict airflow and reduce performance over the system's life, so placement is a decision we make together on site, not something that gets sorted out on install day. The electrical panel also gets opened during the same visit to confirm whether there is room for the dedicated circuit the condenser needs, or whether an upgrade from 100-amp to 200-amp service is required. That cost goes on the estimate as its own line.
Licensed Gas Contractor (LGA0200006)
Authorized Dealer and Installer
Certified Fireplace Dealer
Have a question about your HVAC system? Book an appointment using the form below, or call (604) 535-8434 for immediate help.
Central AC in West Vancouver typically runs $5,000 to $8,000 installed. What moves the price is the house, not the neighbourhood: how far the refrigerant line needs to run between the pad and the furnace, whether the electrical panel has room for the new circuit, and which equipment tier fits the home. Hillside properties in the British Properties and Caulfeild with long vertical line runs and pad work tend to land in the upper half of that range. The assessment is free, the estimate is all-in, and 12-month zero percent financing is available through Financeit.
One day for most homes. The crew sets the outdoor unit on the pad, runs the refrigerant and electrical lines through the wall, mounts the coil above the furnace, connects the condensate drain, and commissions the system before leaving. On hillside homes with a pad a full level below the mechanical room, the vertical line run adds time. Panel upgrades, if needed, may push the project to a day and a half. The estimate confirms the timeline for your home.
A central AC system needs its own dedicated circuit. Most West Vancouver homes built from the 1980s onward have 200-amp panels with room for it. Older Ambleside and Dundarave homes from the 1950s and 60s sometimes carry 100-amp panels that need upgrading first. A certified electrician handles the upgrade as part of the project, and the cost goes on the estimate before you commit. We check the panel during the assessment.
If the furnace has years left and you only want cooling, central AC is the simpler project. If the furnace is aging or you want to cut your gas bill alongside adding cooling, a heat pump does both from the same outdoor unit at a similar install cost. Provincial rebate programs cover heat pumps but rarely cover cooling-only equipment, which often tips the math. As a FortisBC Trade Ally we confirm what applies during the assessment. We quote both during the same assessment so you can compare on real numbers for your home.
Yes, and that is the cheapest time to do it. The indoor coil sits on top of the furnace, so fitting it while the sheet metal is already open saves the return visit. We size the furnace blower for both heating and cooling from the start. Our furnace replacement page covers what a replacement involves.
It depends on the equipment tier and where the unit sits. A variable-speed condenser adjusts its output to the load and runs quietly at partial speed most of the time. A single-stage unit is louder when it kicks on but goes silent between cycles. On West Vancouver lots where the pad is close to a deck, a patio or the property line, the tier choice and the placement together determine what you and your neighbours hear. Both are part of the assessment conversation.
Simply complete our form to make an appointment. A member of our team will be in touch to confirm your appointment.
