Central Air Conditioning for Surrey Homes
Surrey summers have changed. The 2021 heat dome was a wake-up call, and temperatures in the mid to high 30s are now a regular occurrence rather than a rare event. If your home does not have air conditioning, or your existing system is aging, inefficient, or still runs on R-22 refrigerant, now is the time to address it before the next heat wave arrives. Eaton's Heating provides central air conditioner installation across all Surrey neighborhoods from our Coquitlam base. We are an authorized Trane dealer and pair the outdoor condenser with a matched indoor coil on your existing furnace for whole-home cooling through your ductwork. Free written estimates and flexible financing through Financeit with zero percent interest over 12 months.
5 Star Reviews
Years of Experience
Homes Served and Counting
A central air conditioner works with your existing furnace. The outdoor condenser unit sits beside your home and connects via a refrigerant line set to an indoor evaporator coil mounted on top of your furnace. The furnace's blower pushes air across the cold evaporator coil and distributes cooled air through your existing ductwork. This means most Surrey homes with a ducted furnace can add central AC without any ductwork changes, making it one of the more straightforward HVAC upgrades available.
The most common AC installation mistake is incorrect sizing. An oversized unit short-cycles, runs for a few minutes then shuts off before properly dehumidifying the air, leaving rooms cool but clammy. An undersized unit runs constantly on the hottest days and never reaches the thermostat setpoint. We perform manual load calculations on every project, factoring in square footage, insulation, window exposure, ceiling height, and ductwork capacity. The indoor evaporator coil is matched to the outdoor condenser for peak efficiency. Homes in South Surrey and Panorama Ridge with larger floor plans and more window area typically need higher-capacity systems than compact townhomes in Cloverdale or Guildford.
Eaton's Heating is the only authorized Trane dealer in Coquitlam, and we install Trane's full central AC lineup across Surrey. The Trane XV18 variable-speed is our premium option, providing the highest SEER rating and quietest operation. The XR16 offers strong efficiency at a mid-range price point. The XR14 and XR15 Low Profile Side Discharge are reliable options for homeowners who want proven Trane performance in a compact footprint, with the XR15 designed for installations where vertical clearance beside the home is limited. For budget-conscious installations, the RunTru A5AC4 by Trane delivers solid cooling at a lower price point, and the KeepRite NXA6 offers a competitive alternative.
We are a FortisBC Trade Ally, BBB A+ rated, and Technical Safety BC licensed under LGA0200006 with over 20 years of air conditioning installation experience across Greater Vancouver. Our 400+ five-star Google reviews and 4.9 average rating reflect properly sized installations with correct refrigerant charge, verified airflow, and clean commissioning. Every installation includes electrical work by a certified electrician, refrigerant charging to manufacturer specifications, airflow testing at every register, thermostat programming, and factory warranty registration.
On installation day, we set the outdoor condenser on a proper base, run the refrigerant line set and electrical connections, install the matched indoor evaporator coil on your furnace, configure condensate drainage, and connect everything to your thermostat. We verify refrigerant charge, test airflow, and walk you through operation. Most standard AC installations in Surrey are completed in a single day. For homeowners who want both cooling and heating from one outdoor unit, we also install heat pumps that can replace or supplement your furnace. If your existing AC needs repair rather than replacement, we provide honest guidance on which option makes more financial sense for your situation.
Surrey's housing stock affects AC installation in specific ways. Newton and Fleetwood homes from the 1990s and 2000s typically have furnaces with blowers sized for heating only, and the existing ductwork may need inspection to confirm it can handle the additional airflow required for cooling. Sullivan, Bear Creek, and Grandview Heights homes often have more modern ductwork that accommodates AC without modification. Whalley's older homes may need electrical panel evaluation to confirm capacity for the new circuit. We assess every Surrey home's ductwork, electrical panel, and furnace compatibility during the free assessment and include any required upgrades in the written estimate.
For homeowners weighing AC against a heat pump, the decision often comes down to whether you also want heating from the outdoor unit. A standalone AC handles cooling only. A heat pump handles both heating and cooling and may qualify for CleanBC rebates that a standalone AC does not. We present both options during the free assessment and explain the full range of our AC installation services. Visit our rebates page for the latest information on active incentive programs.
Licensed Gas Contractor (LGA0200006)
Authorized Dealer and Installer
Certified Fireplace Dealer
Have a question about your HVAC system? Book an appointment using the form below, or call (604) 535-8434 for immediate help.
Yes. If your home has a ducted furnace, adding central AC is straightforward. The outdoor condenser connects to a matched indoor evaporator coil mounted on your furnace, and the furnace's blower distributes cooled air through your existing ductwork. Most Surrey homes with a functioning ducted furnace can add AC without ductwork modifications. We verify compatibility, duct sizing, and electrical capacity during the free in-home assessment.
SEER (Seasonal Energy Efficiency Ratio) measures cooling efficiency over an entire season. Higher SEER means lower electricity costs per unit of cooling. For Surrey homes, we recommend a minimum SEER of 14, which is the current baseline for new systems. Our most-installed models range from 14 to 18 SEER. The difference in electricity savings between 14 and 18 SEER is meaningful for homes that run AC heavily through July and August, but the upfront cost is higher. The right balance depends on how much you use AC and how long you plan to stay in the home.
An air conditioner only cools. A heat pump cools in summer and heats in winter by reversing the refrigerant cycle. Both use the same basic technology (an outdoor condenser, indoor coil, and refrigerant) and connect to your existing ductwork. The practical difference is that a heat pump can reduce or eliminate your reliance on a gas furnace for heating, which may qualify for CleanBC rebates. A standalone AC costs less upfront but provides cooling only. We help you compare both options during the free assessment.
Central AC installation in Surrey typically costs $4,000 to $7,000 for a standard installation paired with an existing furnace. The range depends on the condenser model selected, the length of the refrigerant line set, and whether electrical upgrades are needed. Installations requiring ductwork modifications or longer line runs cost more. We provide free written estimates that break down all costs clearly. Flexible financing through Financeit with zero percent interest over 12 months.
It depends on your goals. If you only need cooling and your furnace is in good shape, a standalone AC is the more affordable option. If you want both heating and cooling from one system, want to reduce gas consumption, or want to take advantage of CleanBC and FortisBC heat pump rebates, a heat pump is the better long-term investment. Many Surrey homeowners choose a heat pump in a hybrid dual-fuel setup that provides cooling plus efficient heating while keeping the furnace as backup. We present both options with clear pricing during your free assessment.
Most Surrey homes with an existing ducted furnace can add central AC without ductwork changes. The furnace blower pushes air across the new evaporator coil and distributes cooled air through the same ducts used for heating. However, some older homes in Newton, Fleetwood, or Whalley may have undersized ductwork or a furnace blower that cannot handle the additional airflow. We inspect your ductwork and furnace during the free assessment and include any required modifications in the written estimate.
Simply complete our form to make an appointment. A member of our team will be in touch to confirm your appointment.
