Central Air Conditioning for Maple Ridge Homes
Maple Ridge summers get hotter than most of Metro Vancouver, and the homes that managed fine ten years ago are not managing anymore. If you spent last July dragging a portable AC from room to room or sleeping with every window open, central air conditioning ends that permanently. A single outdoor unit paired with your existing furnace cools every room in the house through the ductwork you already have, and for most Maple Ridge homes the installation wraps up in a single day. Eaton's Heating is an authorized Trane dealer and installs central AC across all Maple Ridge neighbourhoods. Free in-home assessments with written estimates. Financeit financing at zero percent interest over 12 months.
See what our customers have to say
Brands Serviced
Years of Experience
Homes Served and Counting
Most Maple Ridge homes with a gas furnace and ductwork can add central air conditioning without touching the existing duct system. The outdoor condenser sits beside the home on a level pad, connects through a refrigerant line set to an indoor evaporator coil mounted on the furnace, and the furnace blower distributes cooled air through the same ducts used for heating. In Cottonwood's 1990s and 2000s homes, Albion's newer builds, Silver Valley's modern construction, and Haney's established residential corridors, the ductwork and furnace infrastructure are typically in place and ready. The assessment confirms that the duct sizing and blower capacity can handle cooling airflow alongside heating, and that the furnace's air handler is compatible with the new coil. For most homes, the entire installation completes in a single day.
Correct sizing is where the installation either succeeds or fails. Maple Ridge's cooling demand varies widely across the city: a west-facing Haney home on a sunny lot absorbs significantly more heat than a shaded Silver Valley property at higher elevation, and a large rural home in Whonnock has a different thermal profile than a compact Cottonwood townhome. We calculate the cooling load for each home during the free assessment, accounting for square footage, insulation, window area and orientation, ceiling height, and duct capacity. The indoor coil is matched to the outdoor condenser so both operate at their rated efficiency. An oversized system cools the thermostat's zone quickly but cuts off before pulling enough humidity out of the air, leaving rooms cool but uncomfortably damp. An undersized system grinds through the hottest afternoons without ever reaching the setpoint.
Eaton's Heating is an authorized Trane dealer and installs Trane's full central AC lineup across Maple Ridge. Trane's variable-speed condensers sit at the top of the efficiency range and run quieter than single-stage units because they modulate output to match cooling demand in real time rather than cycling between full blast and off. Mid-range options balance efficiency and cost for the majority of installations. For side yards and tight setbacks common on Maple Ridge's older residential lots, compact low-profile condensers fit where a standard unit would not. We also install KeepRite and RunTru air conditioners for projects where the budget is the primary consideration. Every condenser is paired with a matched indoor coil so both components operate at their rated efficiency together.
The installation determines whether the system performs for 15 years or generates service calls in its first summer. Eaton's Heating holds TSBC licence LGA0200006, FortisBC Trade Ally status, BBB A+ accreditation, HPCN registration, and full WorkSafeBC coverage. Across 400+ Google reviews averaging 4.9 stars, the pattern on AC installations is that the system cools evenly from the first day and the commissioning was done right. On installation day, we position the condenser on a level base with manufacturer-specified clearances, route the refrigerant line set and electrical conduit through the exterior wall, mount the evaporator coil on the furnace air handler, and configure condensate drainage. A certified electrician runs the dedicated circuit from the panel. We charge the system to manufacturer specifications, verify cooling output and airflow through the duct system, program the thermostat, and register factory warranties before walking you through operation. Most Maple Ridge installations complete in a single day. If your existing AC needs repair rather than replacement, we give you an honest assessment of which path makes more sense. For homeowners who want heating and cooling from one outdoor unit, a heat pump is worth comparing.
AC installations in Maple Ridge vary by property type. Cottonwood and Albion homes with modern electrical panels and accessible side yards are the most straightforward projects. Older Haney homes may need an electrical panel upgrade from 100 to 200 amps to support the dedicated circuit. Hammond's heritage properties with limited exterior access require careful planning for condenser placement and line set routing. Rural Whonnock and Websters Corners properties have plenty of space for the outdoor unit but may need longer refrigerant line runs and conduit from the panel. We evaluate electrical capacity, ductwork condition, furnace compatibility, and outdoor unit placement during the free assessment and include every variable in the estimate.
For homeowners deciding between a standalone AC and a heat pump, the choice depends on whether you also want to reduce gas heating costs. An AC handles cooling only at a lower upfront cost. A heat pump handles both cooling and heating and may qualify for CleanBC rebates that standalone AC does not. We present both options with full pricing during the assessment. Visit our rebates page for current programs.
Licensed Gas Contractor (LGA0200006)
Authorized Dealer and Installer
Certified Fireplace Dealer
Have a question about your HVAC system? Book an appointment using the form below, or call (604) 535-8434 for immediate help.
Central AC paired with an existing furnace typically runs $5,000 to $8,000 in Maple Ridge. The range depends on the condenser tier, the length of the refrigerant line run, and whether the electrical panel needs upgrading. Older homes with 100-amp panels will need a 200-amp upgrade, which adds to the total. Rural properties with longer line set runs from the furnace to the outdoor unit location also sit toward the higher end. Every estimate is free, written, and final. Financeit financing at zero percent interest over 12 months.
Most Maple Ridge homes with a ducted furnace can add central AC without changing the ductwork. The furnace blower pushes air across the new evaporator coil and distributes cooled air through the same supply and return ducts used for heating. In some cases, older homes in Haney or Hammond may have ductwork that was sized only for heating and cannot handle the additional airflow cooling requires. We inspect the duct system during the free assessment and include any modifications in the estimate if needed.
The installation process is similar. Both use an outdoor unit connected to an indoor coil through a refrigerant line set. The difference is what the system does. An AC provides cooling only and pairs with your furnace for heating. A heat pump provides cooling and heating from the outdoor unit, reducing or replacing the furnace's heating role. The heat pump costs more upfront but may qualify for CleanBC and FortisBC rebates that standalone AC does not, and it reduces gas consumption across the heating season. If your furnace is in good shape and you only need cooling, AC is the simpler, less expensive path. If you want to address heating efficiency at the same time, the heat pump handles both in one project.
Variable-speed condensers operate at roughly 55 to 65 decibels during normal operation, which is comparable to a conversation at normal volume. Single-stage units are louder when running, typically 70 to 75 decibels, but cycle off once the home reaches temperature. On Maple Ridge lots where neighbours are close, condenser placement relative to bedroom windows and property lines is part of the site planning. On larger rural lots in Whonnock and Websters Corners, noise is rarely a concern. We factor noise direction into placement during the assessment and can recommend quieter variable-speed options where it matters.
A certified electrician handles every electrical element of the installation: the dedicated circuit from the panel, the conduit run to the outdoor unit, and any panel upgrade required. We secure any required permits and coordinate inspections. There are no charges outside what the estimate quotes.
A standard installation runs five to seven hours from the crew's arrival to the final walkthrough. Projects that require an electrical panel upgrade or a longer-than-standard refrigerant line run on a rural property may extend the timeline. We confirm the expected scope and duration during the free assessment.
Simply complete our form to make an appointment. A member of our team will be in touch to confirm your appointment.
