Regency and Napoleon Fireplace Installation in Port Coquitlam
If your Port Coquitlam home still has the gas fireplace the builder put in 25 or 30 years ago, upgrading to a modern unit is one of the most visible improvements you can make: better glass, a more realistic flame, genuine warmth, and remote and thermostat controls that did not exist when the original went in. Eaton's Heating is a Regency certified dealer and carries Napoleon's residential range. We replace aging builder units and inserts across every Port Coquitlam neighbourhood, and install 18-inch and 24-inch log sets for homeowners who want a simpler upgrade. Every project starts with a free in-home assessment and ends with a written, all-in price. Financeit at zero percent over 12 months is available.
See what our customers have to say
Brands Serviced
Years of Experience
Homes Served and Counting
The builder-installed fireplaces across Glenwood, Oxford Heights, Lincoln Park, and Birchland Manor were basic when they went in: small viewing areas, simple flames, and fans that were never quiet. After 25 to 30 years of service, the difference between one of those aging units and a modern replacement is the difference between an appliance the homeowner barely turns on and one that gets used every evening. The existing gas connection and venting from the original unit typically transfer to the new one with minor adjustments, so the scope stays predictable. The assessment confirms everything before the estimate is written: whether the existing rough opening accepts the new unit directly, what framing or surround work the swap requires, and where the vent termination sits relative to clearances and the exterior conditions.
Citadel Heights homes tend to have higher-end fireplaces that the original homeowner selected rather than accepted from a builder. When those units reach end of life, the replacement is usually about getting a better version of what they already had: a traditional insert with a better flame and more heat, or a contemporary linear design that changes the look of the room entirely. In Central Port Coquitlam's older housing, renovated homes carry gas inserts from the late 1990s that have been running hard every winter and are now at the point where repair costs exceed what the unit is worth. The Fremont area's strata townhomes have newer builder fireplaces that are still within their useful life, but homeowners in those properties occasionally upgrade for style rather than necessity, and strata coordination for exterior vent work is part of what we handle.
For homes where the existing gas firebox is structurally sound, an 18-inch or 24-inch log set is the simplest upgrade: a few hours of work that refreshes the flame and adds modest warmth without the scope or cost of a full replacement. A log set works well when the goal is a better-looking flame at the lowest cost. A complete unit replacement is the stronger investment when the fireplace needs to produce real warmth through the heating season, because an open-firebox log set puts most of its heat up the flue. We quote both when the home could go either way.
Choosing the replacement unit starts with how much heat the room needs and ends with what looks right in the space. Regency's full lineup is manufactured in the Lower Mainland, with a wide range of configuration options across traditional, linear, and panoramic formats. Napoleon's residential range covers every style from high-output traditional inserts to wide contemporary designs. What we tend to recommend in Port Coquitlam, where the heating season runs long enough to justify a fireplace that contributes real warmth, is output matched to the room. The assessment measures for that, and twenty years of fireplace installs across the Lower Mainland is the experience behind the recommendation. Eaton's Heating holds Technical Safety BC licence LGA0200006, Regency certified dealer status, FortisBC Trade Ally, BBB A+, HPCN registered, WorkSafeBC covered, and 400-plus Google reviews at 4.9.
Port Coquitlam's damp valley-floor climate deserves attention at the venting stage. The vent termination on a direct-vent unit exits through an exterior wall, and on homes in lower-lying Port Coquitlam neighbourhoods near the Coquitlam River or in sheltered spots where rain pools against the wall, the termination position needs to account for sustained moisture. Water-resistant cap placement and condensation management inside the vent run are the details that keep the installation trouble-free over the long term. The assessment covers all of this. Every installation runs under a TSBC gas permit we file before work starts and an inspection we book after. Install day ends with every gas connection leak-tested, combustion confirmed, the controls set up, and a walkthrough of operations before we leave.
A log set installation and a full fireplace replacement solve different problems at different costs, and the right choice depends on what the homeowner actually wants from the hearth. A log set drops into a gas firebox that is structurally intact, gives the flame a fresh look, and costs a fraction of a full unit. It is the right project when the firebox is sound, the venting is healthy, and the goal is visual. A full replacement is the right project when the existing unit has reached end of life, when the homeowner wants sealed combustion with real heat output, or when the style no longer fits the room. Replacement pricing for a modern unit in an existing opening typically runs $5,000 to $7,500 all-in, covering equipment, gas work, venting, electrical, finishing, and disposal. Log sets sit well below that range.
The assessment sorts out which project makes sense before any money changes hands. For qualifying installations, FortisBC programs on high-efficiency equipment can offset part of the cost, and we confirm eligibility during the visit rather than promising amounts in advance. Financeit at zero percent over 12 months is available on every project. And if the existing fireplace has a fixable single-part problem rather than being at the end of its life, start with the $169 diagnostic instead.
Licensed Gas Contractor (LGA0200006)
Authorized Dealer and Installer
Certified Fireplace Dealer
Have a question about your HVAC system? Book an appointment using the form below, or call (604) 535-8434 for immediate help.
Replacing a gas fireplace with a modern unit in an existing opening typically runs $5,000 to $7,500 all-in: the unit, gas work, venting, electrical, framing or surround work as needed, finishing, and disposal of the old fireplace. Log set upgrades in a sound gas firebox sit well below that range. The estimate is free, written, and final.
In most cases, yes. Manufacturers build models specifically for this swap market, designed to fit standard rough openings and reuse existing vent paths. When the replacement is a different style or size, a wider linear unit replacing a small square builder box for example, some framing or surround modification may be needed, and the assessment measures for exactly that. The best outcome is a room where the only difference is a dramatically better fireplace. The assessment confirms what your wall needs and what it will cost.
It depends on what is failing and how the costs add up. A single worn component, a thermopile, a fan motor, a thermocouple, is almost always worth fixing, and those repairs typically run $150 to $400. When multiple parts are failing at the same time, or when the unit uses parts that are no longer manufactured, the total repair bill approaches what a modern replacement would cost, and the replacement comes with a full factory warranty and a better fireplace. We lay both options out with real numbers during the $169 diagnostic.
Enough to carry the room it lives in on a cold evening, not enough to replace the furnace. A properly sized unit holds the living space warm and spills useful heat into adjacent open areas. The match between the unit's output and the room's size is what makes the difference: too small and it falls short all winter, too large and it overheats the space within an hour. Getting that match right is what the assessment is for.
A same-opening swap is typically one day: floor protection in the morning, old unit out, new unit set, connected, and tested, room back in service by evening. Log set installations finish in a few hours. The timeline goes in the written estimate so you can plan around it.
By a wide margin. From September through January, the schedule fills with repair and cleaning calls, unit lead times can stretch, and installations compete with the busiest months of the year. Spring and summer are the opposite: lead times are short, the schedule is open, and the unit is broken in and working before anyone in the house needs it.
Simply complete our form to make an appointment. A member of our team will be in touch to confirm your appointment.
